The TC180MC is operated from the control cabinet of the Melt Clean impeller. Once melt treatment is complete, a guided temperature measurement with identification takes place. The measurement results can be transmitted via ethernet or Wi-Fi, e.g. to the IDECO software "QS-Master", and allow the user to control the melt process. The recommended Ni-Cr-Ni surface or insert probes are characterised by a rapid response time of just a few seconds, enabling the user to document the effective temperature after the melt treatment with almost no measuring delay at all.
A signal column indicates the current process step. Simple target value management enables the user to set transparent targets for employees.
Yellow: Sensor is in the melt, measured value is being recorded
Red: Stable temperature is too high or too low
Green: Stable temperature is inside the specified range, temperature acquisition complete
Usable temperature sensors:
We provide a 24-month warranty. The prerequisite for this is annual servicing by IDECO GmbH. (12-month warranty with 3-shift operation)